Did You Know?
Did you know :Apogee Prepress will apply transfer curves on borders and marks?
By default Agfa Apogee Prepress will apply transfer curves (i.e., calibration curves) to any borders and marks within a job. If for some reason this is not desired, this setting can be disabled.
As this setting is in a protected area, please contact your local Agfa Support Center for assistance.
This area will look slightly different depending on what version is being used:
![Apply Transfer Curves on Marks Apply Transfer Curves on Marks](images/Apply-Transfer-Curves-on-Marks.jpg)
![Apply Transfer Curves on Marks from Templates or JDF Layouts Apply Transfer Curves on Marks from Templates or JDF Layouts](images/Apply-Transfer-Curves-on-Marks-from-Templates-or-JDF-Layouts.jpg)